1967 Plymouth Barracuda

I decided to start piecing the car together and get it on the road.  It will not be in final paint or have a new interior, but I’ll be tearing up the streets in it before I die 🙂

Lot’s accomplished tonight:

1. Turn signal issue diagnosed and fixed.  It was a faulty plug by the front of the drivers door where the rear harness connects.  Turn signals all work.
2. Seam sealed the shifter tunnel to seal in the weld
3. Installed the Hurst shifter boot
4. Installed the drivers door handle hardware
5. Installed the passenger seat
6. Installed the interior door panels and all hardware.  The window winders, the armrests and handles.
7. Cleaned up the wiring in the engine compartment
8. Replaced the dimmer switch solving the low-beam/high beam issue